ACU-RITE 100S - Manual (Page 22)

100S General Purpose Reference Manual 19
Troubleshooting
Decimal point
scrolls across
display Press any key or move any
encoder to return to the
previous screen. System has been
idle for approxi-
mately 90 minutes
and is in “display
Screen is
blank Check that the power
switch on the back of the
console is “on.” No power to the
readout
Check that the readout’s
power cord is properly
connected to the power
supply
Check that the power
source meets the specifica-
tions required by your sys-
tem (pg.25)
Contact your 100S GP dis-
tributor for repair/replace-
ment procedures.
LED failure
Dashes ap-
pear on
screen The value entered exceeds
the display’s 8-character
capability. Enter a value
with less than 8
characters.
(Con’t. next page) Display overflow
Check the fuse. (Located
below the power switch).
Symptom Probable Cause
Recommended
Corrective Action