Acura 2011 ZDX - Manual (Page 79)

If the indicator comes on at any other
time, there is a problem with the
CMBS. You will also see a
‘‘CHECK
CMBS SYSTEM ’’ message on the
multi-information display. If this
happens, take your vehicle to a
dealer, and have it checked. For
more information, see page
498 .
When this indicator is on, the CMBS
is not working.
Blind Spot Information
System (BSI) Indicator
On models with blind spot
information system (BSI)
This indicator normally comes on for
a few seconds when you select the
ON mode by operating the engine
start/stop button (see page
194 ).
The BSI indicator also comes on if
the rear bumper becomes dirty while
driving. You will see a
‘‘BLIND SPOT
NOT AVAILABLE ’’ message on the
multi-information display.
When you clean the rear bumper, the
indicator should go off after you
begin driving again.
When you turn the system on, the
indicator will turn off.
If the indicator comes on at any other
time, there is a problem with BSI.
You will also see a
‘‘CHECK BLIND
SPOT SYSTEM ’’ message on the
multi-information display. If this
happens, take your vehicle to a
dealer, and have it checked (for more
information, see page
518 ).
When this indicator is on, BSI is not
working.
Instrument Panel Indicators
75
Instruments
and
Controls
10/07/06 18:05:30 11 ACURA ZDX KA KC MMC North America Own 50 31SZN610 enu
2011 ZDX