Acura 2011 ZDX - Manual (Page 560)

Replacing a Daytime Running
Light Bulb
1. Open the hood.
To change the bulb on the driver's
side, remove the clips by pushing
the center of the clips. Lift the
grommet over the stud bolt and
rotate the heat shield
counterclockwise.
To change the bulb on the
passenger's side, remove the
power steering fluid reservoir by
pulling it out of its stay.
2. Remove the front bulkhead cover
and engine compartment covers
(see page
544 ).
3. Remove the electrical connector
from the bulb by pushing on the
tab and pulling the connector
down.
4. Remove the bulb by turning it one-
quarter turn counterclockwise.
5. Install the new bulb into the hole,
and turn it one-quarter turn
clockwise to lock it in place.
6. Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
7. Test the lights to make sure the
new bulb is working.
8. Reinstall the front bulkhead cover
and engine compartment covers.
On the driver's side
Reinstall the heat shield.
On the passenger's side
Reinstall the power steering fluid
reservoir.
CLIP HEAT SHIELD
GROMMET STUD BOLT
CONNECTOR
BULB
Lights
556
10/07/06 18:05:30 11 ACURA ZDX KA KC MMC North America Own 50 31SZN610 enu
2011 ZDX