ACS AET62 NFC Reader with Fingerprint Sensor - Manual (Page 28)

Appendix A. AET62 PCSC Escape Command
1. Select the “ACS AET62 PICC Interface 0”
2. Select the “Shared Mode” if the “AET62 PICC Interface” is already connected or “Direct Mode if
the “AET62 PICC Interface” is not connected.
3. Press the “Connect” button to establish a connection between the PC and the AET62 reader.
4. Enter
“ 3500 ” in the Command text box
5. Enter the PCSC Escape Command, e.g. “ FF 00 48 00 00 ” and press the “Send” button to send
the command to the reader. #Get the firmware version
6. Press the “Disconnect” button to break the connection.
7. In order to send or receive Escape commands to a reader, follow the instructions below
8. The vendor IOCTL for the Escape command is defined as follows:
#define IOCTL_CCID_ESCAPE SCARD_CTL_CODE(3500)
The following instructions enumerate the steps to enable the PCSC Escape command:
Execute the “RegEdit” in the “Run Command
Menu” of Windows
Document Title Here Document Title Here
Document Title Here AET62 Reference Manual
Version 1.00
Page 28 of 35
[email protected]
www.acs.com.hk