Acroprint HandPunch 4000 - Manual (Page 97)

HandPunch 3000/4000 Manual
95
This is called a “lockout”. Before the rejected ID number can be used again,
another employee or a supervisor must successfully verify at the HandPunch.
• If you enter your ID number, but do not place your hand on the platen, the
HandPunch will time-out in about 25 seconds. You can immediately end
this time-out by the
CLEAR key.
Beeper and LED Status During Verification
The HandPunch’s beeper and LED status display also displays hand
verification information. This information is defined in Table 19 below.
Table 19: Beeper and LED Status During Verification
Operation Beeps LED Meaning
During Keypad
Entry 1 per Keystroke – Keystroke
Accepted
After ID Entry – – OK - Proceed
After ID Entry 2 – ID Number Not in
Database
After Hand
Placement 1 Green ID Verified
After Hand
Placement 2 Red ID Not Verified -
Try Again
After Hand
Placement 1 Long
Continuous
Red ID Refused