Acroprint HandPunch 4000 - Manual (Page 78)

Appendix C - Old Board Configuration
76
Appendix C
Old Board Configuration Information
Wall Plate Installation
1. Loosen the three bottom mounting screws until there is approximately 1/8
inch (3 mm) clearance between the screw head and the wall plate.
2. Remove the HandPunch from its carton.
3. At the base of the HandPunch is a piano hinge with three keyhole shaped
slots that correspond with the three lower mounting screws. Align and
hang the HandPunch from the three lower mounting screws (see below).
2 UPPER SCREWS
HOLE
SURFACE
CONDUIT
ENTRY
KEYHOLE
HOLES
3 LOWER
MOUNTING
SCREWS
REAR OF TERMINAL
Figure 13-1: Attaching the HandPunch to the Wall Plate
4. Tighten all three lower mounting screws.
5. The HandPunch is now ready for its wiring connections.