D. modified buzzer wiring installation, E. standard buzzer installation, F. remote switch control panel final installation – ACR&Artex C406-N User Manual
Page 98
ACR ELECTRONICS, INC / ARTEX PRODUCTS
DESCRIPTION, OPERATION, INSTALLATION AND MAINTENANCE MANUAL
C406-N (453-5060), C406-N HM (453-5061)
25-62-13
Page 98 of 109
MAR 1/13
SUBTASK 25-62-13-450-004
D. Modified Buzzer Wiring Installation
(1)
Splice the wires fabricated in SUBTASK 25-62-13-450-002 on page 97, to the buzzer wires in a
manner acceptable to the aircraft manufacturer, or as described in AC 43.13-1, Paragraph 11-
167, as applicable.
(2)
Route the buzzer wiring through the airframe.
(3)
Support the wiring by clamping or other suitable means, such that the wiring is properly
supported and protected from chaffing and strain. Refer to the aircraft manufacturer’s written
instructions or as described in AC 43.13-1, Chapter 11, § 9 through 12, as applicable.
(4)
Terminate the buzzer wires in accordance with "Figure 34. Remote Switch Control Panel
Wiring Diagram (130-4005 Modified Buzzer)”, on page 96, as follows:
(a)
BLUE wire to remote switch control panel connector Pin 8. Coordinate with SUBTASK 25-
62-13-450-003 on page 97, Step (1).
(b)
YELLOW wire to ELT mating plug Pin 7. Coordinate with SUBTASK 25-62-13-450-002 on
(c)
RED wire to the +28 VDC aircraft battery power source.
(d)
BLACK wire to aircraft ground. See SUBTASK 25-62-13-450-008 on page 74.
SUBTASK 25-62-13-450-005
E.
Standard Buzzer Installation
(1)
See "Figure 35. Remote Switch Control Panel Wiring Diagram (130-4004 Buzzer)”, on
(2)
Fabricate buzzer wiring in accordance with SUBTASK 25-62-13-450-001 on page 67.
(3)
Terminate the buzzer wires in the remote switch harness ELT plug in accordance with
SUBTASK 25-62-13-450-002 on page 72.
(4)
Install the buzzer in accordance with SUBTASK 25-62-13-450-002 on page 94.
(5)
Terminate the buzzer wires to the buzzer in accordance with SUBTASK 25-62-13-450-008 on
SUBTASK 25-62-13-450-006
F.
Remote Switch Control Panel Final Installation
(1)
Connect the remote switch control panel harness plug the remote switch control panel.
(2)
Install the remote switch control panel assembly, referring to SUBTASK 25-62-13-450-002 on