beautypg.com

Remote switch control panel installation, A. location, B. installation – ACR&Artex C406-N User Manual

Page 93

background image

25-62-13

Page 93 of 109

MAR 1/13

ACR ELECTRONICS, INC / ARTEX PRODUCTS

DESCRIPTION, OPERATION, INSTALLATION AND MAINTENANCE MANUAL

C406-N (453-5060), C406-N HM (453-5061)

TASK 25-62-13-450-801

2. Remote Switch Control Panel Installation

SUBTASK 25-62-13-450-001

A. Location

(1)

The control panel must be mounted in the cockpit where the pilot can easily reach the switch

and see the status light.

NOTE: In most cases, panel space and wiring have been pre-provisioned by the aircraft

manufacturer for the control panel; however, location and installation requirements

are defined for installations in aircraft not pre-provisioned for this control panel.

(2)

The panel assembly requires a space approximately 5.74 x 2.24 in. (146 x 57 mm) on the

panel or console surface, with a depth of 3.00 in. (77 mm), excluding room for the harness

connection. See "Figure 32. Cockpit Remote Switch Panel Outline and Dimensions".

Figure 32. Cockpit Remote Switch Panel Outline and Dimensions

SUBTASK 25-62-13-450-002

B. Installation

(1)

Provide an opening in the instrument panel or other mounting location which meets the

dimensional requirements shown in "Figure 32. Cockpit Remote Switch Panel Outline and

Dimensions".

(2)

Mount Dzus rails on the sides of the opening, if necessary. See "Figure 32. Cockpit Remote

Switch Panel Outline and Dimensions" for rail center line dimensions.

(3)

Install the remote switch panel assembly.

NOTE: Step (3) may be completed after wiring is completed on the ELT end and the harness

plug has been plugged into the panel assembly, in accordance with the requirements

of SUBTASK 25-62-13-450-006 on page 98. If such is the case, perform a fit check at

this time.

(4)

Apply a “For Aviation Emergency Use Only/Unauthorized Use Prohibited” placard as close to

the switch as practical, if required.

NOTE: This placard is recommended for installations on aircraft that are not pre-placarded

for remote ELT control. If desired, the placard (591-0428) may be ordered from ACR
Electronics.

CONTROL PANEL

ARTEX AIRCRAFT SUPPLIES,INC

ON

ELT

ELT

ARM

5.74

(146)

5.365

(136.3)

0.185 (4.7)

0.555 (14.1)

1.125 (28.6)

2.24

(57)

4.969

+0.030

-0.000

(126.2

+0.8/-0.0

)

3.000

±0.015

(76.2

±0.4

)

1.13 (29) MAX.

0.69 (18) MAX.

0.37 (9) MIN.

0.06 (2) MIN.

2.094

+0.030

-0.000

(53.2

+0.8/-0.0

)

FRONT VIEW

TOP VIEW

BACK VIEW

453-0161

DIMENSIONS IN INCHES (MM)

FASTENERS (4)

280-0010

(DZUS PA35-38X1426)

This manual is related to the following products: