Appendix b – programming adapter option, Description and operation, A. purpose – ACR&Artex C406-N User Manual
Page 86: B. physical description, Figure 28. programming adapter
ACR ELECTRONICS, INC / ARTEX PRODUCTS
DESCRIPTION, OPERATION, INSTALLATION AND MAINTENANCE MANUAL
C406-N (453-5060), C406-N HM (453-5061)
25-62-13
Page 86 of 109
MAR 1/13
APPENDIX B – PROGRAMMING ADAPTER OPTION
TASK 25-62-13-870-801
1. Description and Operation
SUBTASK 25-62-13-870-001
A. Purpose
(1)
The Programming Adapter (PA) is a C406-N Series ELT option that provides the means to
reprogram the ELT automatically every time the PA determines a new ELT with different
programming has been placed in an aircraft.
(2)
This capability facilitates swapping ELTs from one aircraft to another when performing routine
maintenance, etc., without losing a significant amount of time reprogramming ELTs.
SUBTASK 25-62-13-870-002
B. Physical Description
(1)
The PA is housed in a backshell extension designed for use with the remote switch harness
22-position plug that mates with the ELT.
(2)
The PA circuitry is encapsulated in the backshell extension and has six wires, with pre-installed
contact sockets, that exit the rear of the PA. See "Figure 28. Programming Adapter".
(3)
A wire path through the backshell allows passage of the remote switch wires and other wires
associated with ELT installation.
Figure 28. Programming Adapter
TO REMOTE
SWITCH, ETC.
STRAIN RELIEF
PROGRAMMING ADAPTER
ELT MATING PLUG
ASSEMBLED VIEW
POTTED AREA
WIRE PATH
REAR VIEW
NOTE: ORIENT PA AS SHOWN AT INSTALLATION
TO PREVENT MOISTURE ACCUMULATION.