Fpc 6120 – Acnodes FPC 6120 User Manual

Page 27

661 Brea Canyon Rd., Suite 3

Walnut, CA 91789

tel: 909.598.7388, fax: 909.598.0218

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

FPC 6120

12.1” Industrial fanless Panel PC

4.5 Remove the Back Cover
4.5.1 FPC6120 Back Cover Removal

The back cover is secured to the chassis with nine retention screws, six on the rear
panel and three on the top panel (Figure 4-3). Remove the nine retention screws and lift
the cover off the FPC6120.

4.6 Jumper Settings

The jumper settings are all described in Section 4.6. During normal installation, these
settings should not be changed

4.7 CompactFlash® Card Installation
To install the a CF Type II card onto the FPC6120, please follow the steps below:

Step 1: Locate the CF card socket. Place the FPC6120 on an anti-static pad with the
solder side facing up. Locate the CF card socket.

Step 2: Remove the CF card socket cover. The socket cover is secured to the chassis
with two retention screws. Remove the two retention screws to remove the socket
cover.

Step 3: Align the CF card. Make sure the CF card is properly aligned with the CF
socket.