Accusys ExaSAN SW-08 User Manual
Page 34

3. Installation
2. In the “RAID LEVEL” field, select “R5” from the drop-down list.
3. In the “SAN Software” filed, select “SAN With MetaData” from the drop-down list.
4. Click “Next.”
5. As the result, two logical disks will be created as shown in the screenshot below:
6. Note that once the settings are applied, you will not be able to change RAID settings using Quick
Setup again. Click “Apply” only if your configuration is the same as this example.
User Guide
Page 3-9