Accusys ExaSAN SW-08 User Manual
Page 28

3. Installation
User Guide
Page 3-3
4. Hold the HBA card with mounting plate facing your left. Locate the “mode” jumper switch on the
north edge at center-right, as shown and labeled below.
5. Re-position the HBA card so that you are facing the three switch buttons. Locate the switch pin
button with the label of “1”; make sure that it is in the “OFF” position as shown below. Note that
while there is only the “ON” label, “OFF” is simply at the opposite end of “ON”. The ON/OFF
position of the other two switch pins is irrelevant at this time; the default is set to “OFF.”
6. Position the connector of the card over the slot, insert the connector into the slot, press gently but
firmly until it is securely seated.