FIAT Bravo - Manual (Page 85)

83
SAFETY DEVICES
CORRECT USE OF THE CAR
W
ARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICA
TIONS
INDEX
DASHBOARD AND CONTROLS
BONNET
TO OPEN THE BONNET
Proceed as follows:
❒ pull lever A-fig. 96 in the direction of
the arrow;
❒ pull lever B-fig. 97 and raise the bon-
net.
❒ lift the bonnet and at the same time re-
lease the rod C-fig. 98 from the catch,
then fit the rod end into the bonnet re-
cess D.
IMPORTANT Before opening the bonnet,
check that windscreen wiper arms are not
lifted from the windscreen.
TO CLOSE THE BONNET
Proceed as follows:
❒ hold the bonnet up with one hand and
with the other remove rod C-fig. 98
from recess D and fit it back into its
catch;
❒ lower the bonnet at approx. 20 cen-
timetres from the engine compartment
and then let it drop, ensuring that it is
fully closed and not just held in position
by the safety catch. If the bonnet does
not close properly, do not push it down
but open it again and repeat the above
procedure. If the bonnet is not shut
properly, the instrument panel warning
light ´ or symbol S will turn on to-
gether with the message on the display
(see section “Warning lights and mes-
sages”).
fig. 96 F0Q0689m fig. 97
B
F0Q0690m
fig. 98 F0Q0748m
083-110 BRAVO GB:083-104 BRAVO GB 1-04-2011 15:44 Pagina 83