FIAT Bravo User Manual

Page 83

SAFETY DEVICES

CORRECT USE OF THE CAR

WARNING LIGHTS AND MESSAGES

IN AN

EMERGENCY

CAR

MAINTENANCE

TECHNICAL

SPECIFICATIONS

INDEX

DASHBOARD AND CONTROLS

TO RETURN THE REAR SEAT
BACK TO ITS ORIGINAL
POSITION

Move aside the seat belts, check that they
are not twisted.

Lift the seat backs and push them back-
ward until both coupling mechanisms click
in place, check that the “red band” B-
fig. 92 at the side of levers A is no longer
visible.

The “red band” B indicates missing seat
back coupling.

Reposition the cushions in horizontal po-
sition keeping the centre seat belt tongue
raised.

Total extension

Tilt the rear seat completely to obtain
maximum boot extension.

Proceed as follows:
❒ lower completely the rear seat head re-

straints;

❒ move the seat belt sideways and check

that the belt is not twisted;

❒ fold cushions forward as described pre-

viously;

❒ remove the rear parcel shelf fig. 90 and

release the upper ends A-fig. 91 of the
two tie rods by removing eyelets from
the pins and pushing them in arrow di-
rection;

❒ after tilting the cushion, fold complete-

ly rear seat backs (as described previ-
ously) to have one single surface.

fig. 91

F0Q0687m

fig. 90

F0Q0686m

fig. 92

F0Q0683m

Make sure the seat back is
correctly hooked on both

sides (“red bands” B-fig. 92 not visi-
ble) to prevent seat back being
thrown forwards and injuring pas-
sengers should you brake sharply.

WARNING

058-082 BRAVO GB.qxd 8-04-2010 10:18 Pagina 81