FIAT Bravo - Manual (Page 213)

211
SAFETY DEVICES
CORRECT USE OF THE CAR
W
ARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICA
TIONS
INDEX
DASHBOARD AND CONTROLS
CAR
MAINTENANCE
Changing the windscreen
wiper blades
Proceed as follows:
❒ raise the windscreen wiper arm and po-
sition the blade so that it forms an an-
gle of 90° with the arm;
❒ press tab A-fig. 16 of the coupling
spring and remove the blade to be re-
placed from the arm;
❒ fit the new arm, inserting the tab into
the arm seat. Check for proper locking.
fig. 16 F0Q0662m
Changing the rear
window blade
Proceed as follows:
❒ raise the cover A-fig. 17 and remove
the arm from the car, slackening the nut
B that fastens it to the pivot pin;
❒ fit the new arm, positioning it correct-
ly, and fully tighten the nut;
❒ lower the cover.
SPRAY NOZZLES
Windscreen wiper fig. 18
If the jet of fluid is inadequate, firstly check
that there is fluid in the reservoir: see
“Checking fluid levels” in this section).
Then check that the nozzle holes are not
clogged, if necessary use a needle.
The windscreen jets are fixed.
Rear window wiper fig. 19
Rear window washer jets are fixed.
The nozzle holder is on the rear window.
fig. 17 F0Q0663m
fig. 18 F0Q0661m fig. 19 F0Q0660m
193-216 BRAVO GB:191-212 BRAVO GB 16-03-2011 14:46 Pagina 211