ZyXEL Communications ZyXEL Dimension ES-3024 - Manual (Page 138)

Dimension ES-3024 Ethernet Switch
21-10 Commands Introduction
COMMAND DESCRIPTION
pathcost Displays the specified port’s path
cost.
priority Displays the specified port’s
priority.
edgeport Displays if this port is an edge
port.
p2plink Displays whether the specified
port can connect to one bridge or
multiple bridges.
mcheck Enables the Port Protocol
Migration state machine
(Disabled, Blocking, Listening,
Learning, Forwarding) on the
specified port.
lacp
Refer to IEEE 802.3ad for more
information on link aggregation
control protocol.
agg Displays ports trunked using
LACP.
port
enable Enables LACP on the specified
port.
disable Disables LACP on the specified
port.
status Displays whether LACP is
enabled on the specified port.
actoradm activity [port_no]
[0:passive 1:active]
Allows/disallows the specified
local port to engage in trunking.
actoradm display [port_no] Shows whether the specified
local port is engaged in trunking.
actoradm key [port_no][key] Shows the specified local port
LACP key.
actoradm priority [port_no]
[priority]
Shows the specified local port
LACP priority.
actoradm timeout [port_no]
[0:long_timeout|1:short_timeout]
Enables a short or long timeout
on the specified local port.
status Displays LACP status on all
ports.
keymgnt [on|off] Turns LACP key management
on or off.
syspriority Sets the LACP system priority.
The switch with the lowest
priority becomes the LACP
“server”.
dot1x
“sys sw dot1x” commands relate
to IEEE 802.1X security.