ZyXEL Communications ZyXEL Dimension ES-3024 - Manual (Page 137)

Dimension ES-3024 Ethernet Switch
Commands Introduction 21-9
COMMAND DESCRIPTION
gvrp Enables/disables GVRP on the
specified port.
svlan cpu Sets the VLAN ID of the
management VLAN (CPU).
setentry Applies a static VLAN (name,
admin control tag, tag control) to
a port.
delentry Deletes the specified (VID) static
VLAN.
active Turns on the specified static
VLAN.
inactive Turns off the specified static
VLAN.
list Displays a table of static VLANs.
vlan list Shows the specified IEEE
802.1Q Tagged VLAN table.
status Shows the IEEE 802.1Q tagged
status.
driver config Shows the switch’s settings.
count disp Shows the switch Network Driver
Interface Specifications (NDIS)
level counters (CPU interface).
clear Clears the switch NDIS level
counters (CPU interface).
rstp
All “sys sw rstp” commands
relate to rapid STP configuration.
Refer to IEEE Std 802.1w. Use
“config save” to save your
configuration changes.
bridge
enable Enables RSTP.
disable Disables RSTP.
priority Sets the system priority.
maxage Sets the max age timer
hellotime Sets the hello timer.
forwarddelat Sets the forward delay time
version Displays/enables the STP mode;
STP or RSTP. RSTP is the
default used when configuring
STP via web configurator.
port
enable Enables RSTP on this port.
disable Disables RSTP on this port.