ZyXEL Communications ZyXEL Dimension ES-3024 - Manual (Page 133)

Dimension ES-3024 Ethernet Switch
Commands Introduction 21-5
Table 21-1 command summary
COMMAND DESCRIPTION
pktcnt Display port statistic counter
pktcntclear Reset port statistic counter
port
Port setup
phyread [] Read PHY register
phywrite
Write PHY register
dbm mac cnt [port] Display number in L2 DBM
Dbm mac list [port] Display entries in L2 DBM
Dbm mac search Search the MAC/VID learnt on
which port.
log level [0-4] Sets the log level. Logs displayed
consist of critical, error, warning,
debug and informational
messages in order of severity. Log
level “4” displays all messages; log
level “0” just displays critical
messages.
log switch on/off Outputs messages to the console
or telnet screen.
log list Lists all IXE log modules.
Log module Enable / disable log on specific
IXE module
log switch < on|off > Log all modules to tracelog.
(Current display to console
directly)
memdum Displays the switch chip’s memory
map for the block specified.
wreg Writes to a register.
rreg Reads from a register.
show_int_count Displays the interrupt counter.
clear_int_count Resets the interrupt counter.
socket Displays the system socket’s ID #,
type, control block address (PCB),
IP address and port number of
peer device connected to the
socket (Remote Socket) and task
control block (Owner).
cpu display Displays the CPU’s utilization.
snmp getCommunity [] Sets or displays the SNMP
GetRequest community.