beautypg.com

2 tone commands, Table 22 tone commands – ZyXEL Communications ISDN Terminal Adapter Omni.Net Lite User Manual

Page 70

background image

Omni.Net Lite User’s Guide

69

Chapter 4 Using Tone Commands

4.2 Tone Commands

The tone command sets are shown in the following table. Refer to the corresponding AT
commands in

Chapter 5 on page 72

for more information.

Table 22 Tone Commands

TONE COMMAND

AT COMMAND

DESCRIPTION

991*99#

$F99

Reset all parameters to the factory defaults.

015*#

$P5

Set three-digit country code for caller ID signaling (FSK or

DTMF). The default is 216.

120*n#

\P0

Select CODEC type. Do not change the type until you use

the TA in another country.
n=0: A-law
n=1: -law

121*n#

\P1

Select the dialing method for the analog port.
n=0 indicates overlap sending, and same system as the

traditional telephone (default).
n=1 indicates en-block sending, and you must press “#”

after the phone number.

122*n#

\P2

Configure the analog port priority.
n=0: Both of the analog ports have same priority.
n=1: The PHONE 1 port has higher priority.
n=2: The PHONE 2 port has higher priority.

13d*

[*]#

\Zd

Set a pre-stored phone number for the analog port.
d=0-4: phone number index.
: Enter up to 32 characters, including digits

from 0 to 9, *, #, hyphen ( -), comma (,) and (‘,’). [‘,’] will be

ignored.
: Enter up to 20 ASCII characters ranging

from “0-9”,” a-z” and “A-Z”.

210*n#

!pA0

n=0: Disable the Type 2 caller ID service on the current

analog port.
n=2: Enable the Type 2 caller ID service on the current

analog port.

211*n#

!pA1

n=0: Disable call waiting.
n=1: Enable call waiting (default).

220*n#

!pP0

Set incoming call screen mode for the analog port.
n=0: Accept all incoming calls (default).
n=1: Reject all incoming calls.
n=2: Only accept the calls from the phone number in the list

(see 32d* [*]#).
n=3: Only reject the calls from the phone number in the list

(see 32d* [*]#).

µ