ZyXEL Communications ISDN Terminal Adapter Omni.Net Lite User Manual

Page 61

Omni.Net Lite User’s Guide

Chapter 3 Using AT Commands

\Zd=

number> [/

address>]

Set a pre-stored phone number for the analog port.
d: 0-4
: Enter up to 32 characters, including digits from 0 to 9, *, #,

hyphen ( -), comma (,) and (‘,’). [‘,’] will be ignored.
: Enter up to 20 ASCII characters ranging from “0-9”,” a-z” and

“A-Z”.

!pA0=n

Set the device type of the analog equipment connected to the analog port.
p: enter 1 or 2 to specify the analog port.
n=0: indicates a telephone, telephone with caller ID (type 1), G3 fax or modem

(default).
n=2: indicates a telephone with call waiting caller ID (type 2).

!pA1=n

p: enter 1 or 2 to specify the analog port.
n=0: Disable call waiting.
n=1: Enable call waiting (default).

!pId=

number> [/

address>]

Create a list of the phone numbers for incoming call screening on the analog

port.
p: enter 1 or 2 to specify the analog port.
d=0-4.
: Enter up to 32 characters, including digits from 0 to 9, *, #,

hyphen ( -), comma (,) and (‘,’). [‘,’] will be ignored.
: Enter up to 20 ASCII characters ranging from “0-9”,” a-z” and

“A-Z”.

!pOd= Create a list of the prefix digits for outgoing call screening on the analog port.

p: enter 1 or 2 to specify the analog port.
d=0-2

!pP0=n

Set incoming call screen mode for the analog port.
p: enter 1 or 2 to specify the analog port.
n=0: Accept all incoming calls (default).
n=1: Reject all incoming calls.
n=2: Only accept the calls from the phone number in the list (see !pId=

number> [/]).
n=3: Only reject the calls from the phone number in the list (see !pId=

number> [/]).

!pP1=n

Set outgoing call screen mode for the analog port.
p: enter 1 or 2 to specify the analog port.
n=0: No restriction (default).
n=1: Prohibit all outgoing calls.
n=2: Only accept the calls with the prefix in the pre-defined list (see
!pOd=).
n=3: Only reject the calls with the prefix in the pre-defined list (see
!pOd=).

!pP2=n

Select CLIP (Calling Line Identification Presentation) or CLIR (Calling Line

Identification Restriction) for the analog port.
p: enter 1 or 2 to specify the analog port.
n=0 indicates you select CLIR and the ISDN switch will not pass your phone

number to the destination site.
n=1 indicates you select CLIP and the ISDN switch will pass your phone number

to the destination site.

Table 15 AT Command Sets for the Analog Port

COMMAND

DESCRIPTION