ZyXEL Communications ISDN Terminal Adapter Omni.Net Lite - Manual (Page 51)

Omni.Net Lite User’s Guide
Chapter 2 Using the Utility 50
Figure 18 Analog Port: Supplementary Service
2.12.4.4 Call Transfer
You can transfer a call to a local phone (connected to the TA) or a remote phone (not
connected to the TA) through an ISDN line.
2.12.4.4.1 Call Transfer between Two Analog Ports
To transfer incoming calls (after you answer this call) to a local phone, follow these steps:
1 Press the flash key to put the caller on hold.
2 When you hear the dial tone, dial “1#” to operate the Intercom.
3 After you hear the ring signal or the second party answer it, press the flash key, then “4”.
4 Hang up the phone.
2.12.4.4.2 Call Transfer to a Remote Phone
To transfer incoming calls (after you answer this call) to a remote phone, follow these steps:
1 Press the flash key to put the caller on hold.
2 When you hear the dial tone, simply dial the number you want, to transfer the first call.
3 After you hear the ring signal or the second party answer it, press the flash key, then “4”.