ZyXEL Communications P-660HW-TX - Manual (Page 83)

P-660HW-Tx v2 Series Support Notes
(3) Delete items from the auto-haunting preconfigured table by useing
command:
wan atm vchunt remove
• Using Zero configuration.
You can enable/disable Zero Configuration in Network -> WAN -> Advanced
Setup:
(1) After configure the auto-haunting preconfigured table. You just need a PC
connected to the device LAN Ethernet port with the DSL sync up.
(2) Open your web browser to access a Web site. It should prompt and request
for your username password of your ISP account, if your ISP provide PPPoE
or PPPoA service.
(3) After key-in the correct info, it will than test the connection. If it is
successful it will than close the browser and you can open a new browser to
surf the Internet. If the connection test fail, it will go back to the page ask for
user name and password.
82
All contents copyright © 2006 ZyXEL Communications Corporation.