ZyXEL Communications P-660HW-TX User Manual

Page 46

P-660HW-Tx v2 Series Support Notes

For example, if the workstation operating Cu-SeeMe has an IP of 192.168.1.34,
then the default SUA server must be set to 192.168.1.34. The peer Cu-SeeMe
user can reach this workstation by using P-660HW-Tx v2's WAN IP address
which can be obtained from Web Configurator, Status -> WAN Information.

Configure an Internal Server behind SUA

Introduction

If you wish, you can make internal servers (e.g., Web, ftp or mail server)
accessible for outside users, even though SUA makes your LAN appear as a
single machine to the outside world. A service is identified by the port number.
Also, since you need to specify the IP address of a server behind the
P-660HW-Tx v2, a server must have a fixed IP address and not be a DHCP
client whose IP address potentially changes each time P-660HW-Tx v2 is
powered on.

In addition to the servers for specific services, SUA supports a default server.
A service request that does not have a server explicitly designated for is