ZyXEL Communications P-660HW-TX - Manual (Page 47)

P-660HW-Tx v2 Series Support Notes
forwarded to the default server. If the default server is not defined, the service
request is simply discarded.
Configuration
To make a server visible to the outside world, specify the port number of the
service and the inside address of the server in Web Configurator, Advanced
Setup, Network -> NAT -> Port Forwarding. The outside users can access
the local server using the P-660HW-Tx v2's WAN IP address which can be
obtained from Web Configurator, Status -> WAN Information.
For example:
Configuring an internal Web server for outside access (suppose the
Server IP Address is 192.168.1.10 ) :
(1) Fill in the service name and server IP Address, press button ‘Add’
(2) If add successfully, the Web Configurator will display message
‘Configuration updated successfully’ at the bottom. You can see the port
forwarding rule on the same page, the default port for Web Server is 80:
46
All contents copyright © 2006 ZyXEL Communications Corporation.