ZyXEL Communications 2864I - Manual (Page 78)

Dial-In Configuration 65
16. Session Options: Input Filter Sets and Session Options:
Output Filter Sets - In these fields, you need to select the
filter set(s) to filter the incoming and outgoing traffic between
your Prestige and the Remote Dial-in User. Keep in mind that
these filter set(s) will only apply to all Remote Dial-in Users but
not the Remote Nodes.
You can choose from 12 different filter sets. In addition, you
can link up to 4 filter sets together for further customization
(e.g., 1, 5, 9, 12). Note that spaces and , are accepted in this
field. For more information on customizing your filter sets, see
Chapter 10 on Filter Configuration. The default is blank, i.e., no
filters.
17. Session Options: Idle Timeout - This value is the number of
idle seconds that elapses before the dial-in user is automatically
disconnected. Idle Timeout is the period of time when there is
no data traffic between the dial-in user or Remote Node and
the Prestige. This field will only be used if the Recv. Authen is
set to None and the call is not mapped to any Remote Node or
Remote Dial-in User or the Prestige calls back to the Remote
Dial-in User. There is no Idle Timeout for incoming calls.
Once you have completed filling in Menu 13 - Default Dial-in
Setup, press ENTER at the message: Press ENTER to Confirm ...
to save your selections, or press ESC at any time to cancel your
selections.
Dial-In Users Setup
The following steps describe the setup procedure for adding a
Remote Dial-in User. From the Main Menu, enter 14 to go to 14.
Dial-in User Setup is shown below: