A warning on connection cables, Connecting your computer and your prestige, Connecting the rs-232 cable to your prestige – ZyXEL Communications 2864I User Manual
Page 35: Connecting an isdn line to your prestige

22 Installation
A Warning On Connection Cables
The RS-232, ISDN line, and Ethernet cable, are very similar to
each other. It is important that you use the correct cable for each
connection; otherwise, your Prestige could be damaged.
Connecting Your Computer and Your Prestige
For the initial setup of your Prestige, you must use an RS-232 cable
and communications software to configure the Prestige.
After the Prestige has been successfully installed, you can modify
the configuration through a remote Telnet connection. See Chapter
13 for detailed instructions on using Telnet to configure your
Prestige.
Connecting the RS-232 Cable to your Prestige
To connect the RS-232 cable, first click open the door on the right
panel to reveal the port. Plug one end of the RS-232 cable (looks
like a telephone jack) into the port until the retainer clicks into
place. Connect the other end of the RS-232 cable to the serial port
(COM1, COM2, or any other COM port) of your computer.
Connecting an ISDN Line to your Prestige
Plug one end of your ISDN phone line which is included in your
package into the socket on the rear panel of the Prestige labeled
ISDN and the other end into the ISDN wall jack.
•
S/T interface - This can only connect to your NT-1 (Network
Termination) device.
2
2
11
27(
27(
'
212781'(5$1<&,5&8067$1&(6&211(&7',5(&7/<727+(
,6'1
:$//
-$&.