ZyXEL Communications 2864I - Manual (Page 128)

Telnet Configuration and Capabilities 115
Telnet Configuration and
Capabilities
About Telnet Configuration
When you first configure your Prestige, it must be done via a
computer connected to the RS-232 port. However, once the
Prestige has been initially configured, you can use
telnet to
configure the device remotely as shown below:
Figure 13-1 Telnet Configuration on a TCP/IP Network
In order to configure your Prestige in this way, you need to have
assigned an IP Address to your device and have connected it to
your network. See Chapter 3 for more information on assigning an
IP Address. Once this is configured, any station on the LAN or
remote network that has TCP/IP installed can use
telnet remote
management. If your Prestige is configured for IPX routing but not