ZyXEL Communications ADSL2+ Ethernet Gateway P-660R-T Series - Manual (Page 43)

P-660R-T Series User’s Guide
43 Chapter 2 Introducing the Web Configurator
WAN WAN Setup Use this screen to change the Prestige’s WAN remote node
settings.
WAN Backup Use this screen to configure your traffic redirect properties and
WAN backup settings.
NAT SUA Only Use this screen to configure servers behind the Prestige.
Full Feature Use this screen to configure network address translation
mapping rules.
Security Use this screen to configure Internet security and apply the
predefined filter rules.
Dynamic DNS Use this screen to set up dynamic DNS.
Time and Date Use this screen to change your Prestige’s time and date.
Remote
Management
Use this screen to configure through which interface(s) and from
which IP address(es) users can use Telnet/FTP/Web to manage
the Prestige.
UPnP Use this screen to enable UPnP on the Prestige.
Maintenance
System Status This screen contains administrative and system-related
information.
DHCP Table This screen displays DHCP (Dynamic Host Configuration
Protocol) related information and is READ-ONLY.
Any IP Table This screen shows current read-only information of all network
devices that use the Any IP feature to communicate with the
Prestige.
Diagnostic General These screens display information to help you identify problems
with the Prestige general connection.
DSL Line These screens display information to help you identify problems
with the DSL line.
Firmware Use this screen to upload firmware to your Prestige
LOGOUT Click this label to exit the web configurator.
Table 3 Web Configurator Screens Summary (continued)
LINK SUB-LINK FUNCTION