ZyXEL Communications ADSL2+ Ethernet Gateway P-660R-T Series - Manual (Page 153)

P-660R-T Series User’s Guide
153 Chapter 18 Remote Node Configuration
Figure 85 Menu 11.8 Advance Setup Options
Menu 11.8 - Advance Setup Options
PPPoE pass-through= No
Press ENTER to Confirm or ESC to Cancel:
The following table describes the fields in this menu.
Table 46 Menu 11.8 Advance Setup Options
FIELD DESCRIPTION
PPPoE pass-through Press [SPACE BAR] to select Yes and press [ENTER] to enable PPPoE pass
through. In addition to the Prestige's built-in PPPoE client, you can enable
PPPoE pass through to allow up to ten hosts on the LAN to use PPPoE client
software on their computers to connect to the ISP via the Prestige. Each host
can have a separate account and a public WAN IP address.
PPPoE pass through is an alternative to NAT for applications where NAT is not
appropriate.
Press [SPACE BAR] to select No and press [ENTER] to disable PPPoE pass
through if you do not need to allow hosts on the LAN to use PPPoE client
software on their computers to connect to the ISP.
When you have completed this menu, press [ENTER] at the prompt “ Press ENTER to Confirm
or ESC to Cancel: ” to save your configuration, or press [ESC] at any time to cancel.