ZyXEL Communications ADSL2+ Ethernet Gateway P-660R-T Series - Manual (Page 218)

P-660R-T Series User’s Guide
Chapter 26 System Maintenance 218
C
H A P T E R
26
System Maintenance
This chapter leads you through SMT menus 24.8 to 24.10.
26.1 Command Interpreter Mode
The Command Interpreter (CI) is a part of the main system firmware. The CI provides much of
the same functionality as the SMT, while adding some low-level setup and diagnostic
functions. Enter the CI from the SMT by selecting menu 24.8. See the included disk or the
zyxel.com web site for more detailed information on CI commands. Enter 8 from Menu 24 —
System Maintenance. A list of valid commands can be found by typing help or ? at the
command prompt. Type “ exit ” to return to the SMT main menu when finished.
Figure 147 Command Mode in Menu 24
Menu 24 - System Maintenance
1. System Status
2. System Information and Console Port Speed
3. Log and Trace
4. Diagnostic
5. Backup Configuration
6. Restore Configuration
7. Upload Firmware
8. Command Interpreter Mode
9. Call Control
10. Time and Date Setting
11. Remote Management
Enter Menu Selection Number:
Figure 148 Valid Commands
Copyright (c) 1994 - 2004 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys exit device ether
wan poe ip ppp
bridge hdap
ras>