ZyXEL Communications NPS-520 - Manual (Page 39)

Chapter 3 Web Configurator
NPS-520 User’s Guide
39
3.5 The System Screen
Use this screen to change the NPS-520’s system name and management password.
Figure 17 Web Configurator: System
The following table describes the labels in this screen.
Printer Status These fields are blank if no printer is connected.
Printer Model
Number
This displays the model name of the printer currently connected to the NPS-520.
Manufacturer This displays the manufacturer name of the printer currently connected to the
NPS-520.
Printing Language
Supported
This displays the printing languages supported by the printer currently connected
to the NPS-520.
A. Hexadecimal characters are 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, A, B, C, D, E, and F.
Table 11 Web Configurator: Status (continued)
LABEL DESCRIPTION
Table 12 Web Configurator: System
LABEL DESCRIPTION
Server Name
Setup
Server Name Enter a descriptive name for identification purposes. By default, the generated
server name begins with “ZyXEL” and is followed by the last three characters of
the NPS-520’s MAC address.
This name can be up to 30 alphanumeric characters long. Spaces are not
allowed, but dashes “-” and underscores "_" are accepted.
Password Setup
Old Password Type the default password or the existing password you use to access the system
in this field. If you forget the password, you may have to use the hardware RESET
button. This restores the default password of 1234.
Password Type your new system password (up to 7 printable characters). Note that as you
type a password, the screen displays a (*) for each character you type.
Re-type Password Type the new password again for confirmation.