ZyXEL Communications NPS-520 - Manual (Page 38)

Chapter 3 Web Configurator
NPS-520 User’s Guide
38
Figure 16 Web Configurator: Status
The following table describes the labels in this screen.
Table 11 Web Configurator: Status
LABEL DESCRIPTION
Refresh Interval Select a number of seconds or None from the drop-down list box to update all
screen statistics automatically at the end of every time interval or to not update
the screen statistics.
Refresh Click this button to update the status screen statistics immediately.
System
Information
Device Name This is the default name of your NPS-520. It begins with “ZyXEL” and is followed
by the last three characters of the NPS-520’s MAC address.
Print Server Name This is the Server Name you enter in the System screen. It is for identification
purposes.
Model Type This is the model name of your NPS-520.
Firmware Version This is the version of the Firmware currently on the NPS-520.
MAC Address This is the MAC (Media Access Control) address of the NPS-520. Every device
that can use a network has a unique identification number, called a MAC address.
The MAC address is assigned at the factory and consists of six pairs of
hexadecimal characters A , for example, 00:A0:C5:00:00:02.
RAW Printing This indicates that the NPS-520 supports the RAW printing protocol (Enable).
IPP Printing This indicates that the NPS-520 supports the IPP printing protocol (Enable).
LPR Printing This indicates that the NPS-520 supports the LPR printing protocol (Enable).
TCP/IP
Information
DHCP If the NPS-520 is set to get its IP address automatically from a DHCP server in
the network to which the NPS-520 is connected, this displays On.
If the NPS-520 is using a manually entered static (fixed) IP address, this displays
Off.
IP Addr/Netmask This shows the NPS-520’s IP address and subnet mask.
Gateway This shows the gateway’s IP address you configured in the Setup TCP/IP screen.