Zoom 1065 - Manual (Page 15)

(if you are NOT using a static IP address) or on page 20 (if you
have a static IP address).
¾
Select AUTOMATICALLY if neither of the special
circumstances mentioned above fits your situation. When
this option is selected, the screen changes to show
automatic configuration options. Do the following:
a
Select the Enable option button, then click Save
Changes.
b
The page changes to the Autodetect page and a Start
button appears. Click the Start button to begin the
automatic configuration. A message appears to let you
know that the current configuration, if any, will be lost
when the X5 configures itself. Click OK to dismiss
this message.
c
Wait while the X5 modem searches for the correct
VPI, VCI, and Encapsulation settings and connects
with your Internet service provider. This may take a
few minutes because the modem must try various
combinations until it finds the settings that match your
service provider’s.
3
Once the modem detects your settings, your VPI, VCI, and
Encapsulation settings will appear in the table on the
Autodetect page. Click the Encapsulation setting to continue
with the process.
When your Encapsulation
setting appears, click it to
continue with the process.
(Note that yours may be
something other than
PPPoE.)
Chapter 1: Installation Instructions 15