Zebra Technologies S400 User Manual
3еkв¿емчbk
This manual is related to the following products:
Table of contents
Document Outline
- Introduction 1
- Getting Ready to Print 7
- Routine Care and Adjustments 27
- Troubleshooting 45
- Specifications 61
- Appendix 67
- Glossary 71
- Index 75
- Tear-Off Mode
- Peel-Off Mode
- Cutter Mode
- Ribbon Supply Spindle: Normal Position
- Ribbon Supply Spindle: Low-Tension Position
- Ribbon Loading Instructions
- Non-Continuous Media
- Continuous Media
- Front Panel Buttons
- RS-232 Interface Requirements
- Parallel Interface Requirements
- Serial and Parallel Cabling Requirements
- Via the Parallel Port
- Via the Serial Port
- Cleaning the Exterior
- Cleaning the Interior
- Cleaning the Printhead and Platen Roller
- Cleaning the Cutter Module
- Print Quality Adjustments
- Toggle Pressure Adjustment
- Media Rest Position Adjustment
- Top of the Label Position Adjustment
- Media Sensor Position Adjustment
- Ribbon Supply Spindle Adjustment
- Resetting Factory Defaults
- Resetting Communications Parameters
- Resetting Ribbon Parameters
- Power-On Self Test
- Additional Printer Self Tests
- CANCEL Key Self Test
- PAUSE Key Self Test
- FEED Key Self Test
- MODE Key Self Test
- Interconnecting to DTE Devices
- Interconnecting to DCE Devices
- A
- B
- C
- D
- F
- G
- I
- L
- M
- N
- O
- P
- R
- S
- T
- U
- Z