Zebra Technologies S400 - Manual (Page 19)

Zebra S400 & S600 User’s Guide 11
3HHO2II 0RGH
(Peel-Off mode is optional).
Refer to Figure 9 and follow the procedure below.
1. Slide the media supply guide (a), media guide (b), and the outer edge
guides on both the platen guide rod (c) and the lower guide rod (d) as
far out from the printer frame as possible.
2. Open the head open lever (e) to raise the printhead (f).
3. Remove the hold down hook (g).
4. Thread the media through the printhead as shown in Figure 9.
5. From the front of the printer, pull the media through the printhead until
approximately 24" of media extends out from the printer. Remove the
labels from the backing of the 24" of media that extends from the front
of the printer.
6. Align the inside edge of the media with the edge guide mark (h) near
the left side of the tear-off/peel-off plate, then close the head open
lever. (See Figure 25 on page 52 for a detailed illustration.)
7. Thread the label backing behind the lower label available sensor (i),
through the slot under the rewind power roller (j), and below the lower
guide rod (k) to the backing rewind spindle (l). Then, wind the
backing material around the backing rewind spindle three or four
times in a counterclockwise direction. To ensure proper winding,
press the edge of the backing material against the round plate at the far
end of the spindle.
8. To hold the media against the spindle, place the hold down hook over
the backing and insert both ends into the small slots in the round plate
at the far end of the spindle. Again, rotate the backing rewind spindle
counterclockwise to remove any slack in the backing material.