Zebra Technologies S400 - Manual (Page 64)

56 Zebra S400 & S600 User’s Guide
$GGLWLRQDO 3ULQWHU 6HOI 7HVWV
These self tests produce sample labels and provide specific information
that help the operator determine the operating conditions for the printer.
Each self test is enabled by holding in a specific front panel button while
turning the power switch on. Keep the button depressed until the
CALIBRATE LED goes out. When the Power-On Self Test is complete,
the selected printer self test automatically starts. To return to printing
mode, turn off and then turn on the printer.
NOTE: When performing self tests, disconnect all
communications interface cables from the printer.
NOTE: When canceling a self test before its actual completion,
always turn the printer power switch off and then back on.
NOTE: When performing these self tests while in the Peel-Off
mode, the operator must remove the labels as they become
available.
NOTE: When the cutter option is installed and enabled, the labels
printed in these self tests should be automatically cut as they are
printed.