Zebra Technologies Zebra S Series 105SL User Manual
Page 72
48
105SL User Guide
6/4/2004 11342L Rev. 8
Configuration
Configuration and Calibration LCD Displays
LIST FONTS
List Fonts: Press the (+) key to print a label listing all available fonts.
This selection is used to print a label listing all fonts available in the printer, including
standard printer fonts plus any optional fonts. Fonts may be stored in RAM, Flash
memory, font EPROMs, or font cards.
LIST BAR CODES
List Bar Codes: Press the (+) key to print a label listing all available bar codes.
This selection is used to print a label listing all bar codes available in the printer.
LIST IMAGES
List Images: Press the (+) key to print a label listing all available images.
This selection is used to print a label listing all images stored in the printer’s RAM,
Flash memory, optional EPROM, or optional memory card.
LIST FORMATS
List Formats: Press the (+) key to print a label listing all available formats.
This selection is used to print a label listing all formats stored in the printer’s RAM,
Flash memory, optional EPROM, or optional memory card.
LIST SETUP
List Setup: Press the (+) key to print a label listing the current printer configuration.
This selection is used to print a label that lists the current printer configuration
information. (Same as CANCEL Key Self Test.)
LIST NETWORK
List Network Settings: Press the (+) key to print a label that lists the current network
configuration. (Same label as shown in
This selection is used to print a network configuration label, which lists the settings for
the wired ZebraNet PrintServer II (PSII) and the ZebraNet Wireless Print Server (if
installed).
LIST ALL
List All: Press the (+) key to print a label listing all available fonts, bar codes, images,
formats, and the current printer and network configurations.
This selection is used to print a label that lists the five previous selections, as described.
FORMAT CARD
A
B
Initialize Memory Card
Caution • Perform this operation only when it is necessary to erase all previously
stored information from the optional memory card.
1.
Press SELECT to select the parameter.
If your printer is set to require a password, you are prompted to enter the password.
2.
Enter the password, then press SELECT.
3.
Press the PLUS (+) to select B memory (PCMCIA card) or press MINUS (–) to
select the A memory (internal compact flash).
The front panel LCD asks
ARE YOU SURE?
.
4.
Press MINUS (–) to select
No
and cancel the request.
The
INITIALIZE CARD
prompt is displayed.
OR
Press PLUS (+) to select
YES
and begin initialization.
FORMATTING CARD
displays. Depending on the amount of memory in the
memory card, initialization may take up to three minutes to complete. When
formatting is complete,
FORMAT CARD
displays.
5.
Press SELECT to continue with the next prompt.
Table 6 • Printer Parameters (Sheet 3 of 11)
Parameter
Action/Explanation