Zebra Technologies Zebra S Series 105SL - Manual (Page 67)

Configuration
Overview
11342L Rev. 8 6/4/2004 105SL User Guide 43
Exit Setup Mode
To leave Setup Mode, complete these steps:
1. Press SETUP/EXIT .
The LCD displays SAVE CHANGES .
2. Press the Plus (+) or Minus (–) to display the save options ( Table 4 ).
3. Press NEXT/SAVE to select the displayed choice.
When the configuration and calibration sequence is done, PRINTER READY displays.
Table 4 • Save Options When Leaving Setup Mode
LCD Display Description
PERMANENT Permanently saves the changes. Values are stored in the printer even when
power is turned off.
TEMPORARY Saves the changes until you change them again or until power is turned off.
CANCEL Cancels all changes from the time you pressed SETUP/EXIT except the
darkness and tear-off settings (if they were changed).
LOAD DEFAULTS Sets all parameters other than the network settings back to the factory defaults.
Note • Loading factory defaults causes the printer to auto-calibrate.
LOAD LAST SAVE Loads values from the last permanent save.
DEFAULT NET Sets the wired and wireless network settings back to factory defaults.