Zebra Technologies Zebra S Series 105SL - Manual (Page 52)

28 105SL User Guide 6/4/2004 11342L Rev. 8
Printer Operation
Removing the Label Liner
Removing the Label Liner
Because the rewind spindle holds the liner from a standard-size media roll, perform this
procedure whenever you change the media. You do not need to turn off the printer to perform
this procedure.
To remove the liner from the rewind spindle, follow these steps:
1. Unwind approximately 36 in. (915 mm) of liner from the rewind spindle. Cut it off at the
spindle.
2. Pull out the hook. Slide the liner off of the rewind spindle and discard.
3. Wind the media around the rewind spindle once or twice and reinstall the hook. Continue
winding to remove any slack in the media.