Zebra Technologies Zebra S Series 105SL - Manual (Page 66)

42 105SL User Guide 6/4/2004 11342L Rev. 8
Configuration
Overview
Overview
After you have installed media and ribbon and printed a configuration label, you can change
the printer’s settings using the front panel controls. For an overview of the front panel,
including descriptions of the buttons and lights, see
Operator Controls on page 3 . If you need
to restore the printer to its factory default settings, see FEED and PAUSE Self Test on page 89 .
Many printer settings may be controlled by your printer’s driver or label preparation software.
Refer to the driver or software documentation for more information.
Enter Setup Mode
To enter Setup Mode, press SETUP/EXIT. Press either NEXT/SAVE or PREVIOUS to
scroll to the parameter you wish to set.
Parameters in this section are shown in the order displayed when pressing NEXT/SAVE.
Throughout this process, press NEXT/SAVE to continue to the next parameter, or press
PREVIOUS to return to the previous parameter in the cycle.
An asterisk (*) in the upper left-hand corner of the LCD indicates that the value displayed is
different from the currently stored value.
Note • Printers that are operating on an IP network can be quickly configured in the following
ways:
• with the ZebraLink
® WebView (ZebraNet ® PrintServer II required). For information, see
the ZebraNet Networking: PrintServer II Installation and User Guide.
• with the SetWLAN configuration utility (ZebraNet Wireless Print Server required). For
information, see the ZebraNet Wireless Print Server User Guide.
Note • You may also press and hold NEXT/SAVE and PREVIOUS to advance quickly
through the configuration parameters.