Rewind media alignment, 5hzlqg 0hgld $oljqphqw – Zebra Technologies Z6M User Manual

Page 75

Text mode
Original mode

Zebra Z4M/Z6M Printers User’s Guide

5HZLQG 0HGLD $OLJQPHQW

(Rewind option required)

NOTE: The media /backing should be installed flush against the backplate of
the take-up spindle to prevent the media/backing from winding too loosely.

Perform the following adjustment if the media does not track properly onto the
take-up spindle.

Refer to Figure 29.

1. Turn the adjustment dial clockwise to align the media/backing material toward the

inboard (i.e., mainframe or electronics) side. This is the most likely adjustment.

2. Turn the dial counterclockwise to align the media/backing material toward the

outboard (i.e., away from the mainframe or electronics) side.

Figure 29

Printhead

Assembly

Adjustment

Dial

Take-up

Spindle

Backplate