Zebra Technologies Z6M - Manual (Page 72)

64 Zebra Z4M/Z6M Printers User’s Guide
&OHDQLQJ WKH &XWWHU 0RGXOH
(Cutter option required)
:$51,1* )RU SHUVRQQHO VDIHW\ $/:$<6 WXUQ RII DQG XQSOXJ
WKH SULQWHU EHIRUH SHUIRUPLQJ WKLV SURFHGXUH
Refer to Figure 27.
To clean adhesive off of the upper and lower cutter blades:
1. Remove the cutter shield by removing the thumbscrew and lock washer.
2. Use a swab moistened with solvent to wipe along the upper cutter blade.
3. To expose the lower cutter blade, turn the cutter motor thumbnut counterclockwise
until you see the “V”-shaped lower cutter blade.
4. Clean the lower blade, following the instructions in step 2.
5. Replace the cutter shield.
6. When you have finished cleaning the cutter module, plug in and turn on the printer.
The lower cutter blade returns to its correct operating position.
If the cutter continues to perform unsatisfactorily, contact an authorized service
technician.
Figure 27
Upper
Cutter
Blade
Lower
Cutter
Blade
Cutter
Motor
Thumbnut
Cutter
Shield
Thumbscrew
and
Lock Washer