Zebra Technologies Z6M - Manual (Page 37)

Zebra Z4M/Z6M Printers User’s Guide 29
16.Close the printhead assembly.
17.Close the value peel assembly using the value peel lever.
18.If the printer is paused (the PAUSE light is on), press the PAUSE key to enable
printing.
Peeling starts automatically. Press the FEED key to test.
Liner Removal
1. Cut the liner material between the media alignment spindle and the take-up
spindle.
2. Rotate the take-up spindle counterclockwise until the rewind media guide is in the
“12 o’clock” position.
3. Loosen the thumbscrew and slide out the rewind media guide to the end of the
take-up spindle.
4. Slide the core with the liner material from the take-up spindle.
Figure 18
Label
Media Supply Guide
Media
Guide
Ribbon
Sensor
Media Supply
Hanger
Media
Alignment
Spindle
Printhead
Open Lever
Take-up
Spindle
Rewind Media
Guide
Thumbscrew
Printhead
Assembly
Transmissive
Sensor
Dancer
Value
Peel
Lever
Value
Peel
Assembly