Zebra Technologies Z6M - Manual (Page 39)

Zebra Z4M/Z6M Printers User’s Guide 31
14.Slide the rewind media guide against the media, and tighten the thumbscrew to
lock it into position.
15.Close the printhead assembly.
16.If the printer is paused (the PAUSE light is on), press the PAUSE key to enable
printing.
Media Removal
1. Cut the media between the media alignment spindle and the take-up spindle.
2. Rotate the take-up spindle counterclockwise until the rewind media guide is in the
“12 o’clock” position.
3. Loosen the thumbscrew and slide out the rewind media guide to the end of the
take-up spindle.
4. Slide the core with the roll of media from the take-up spindle.
Figure 19
Value
Peel
Lever
Media Supply Guide
Media
Guide
Ribbon
Sensor
Media
Supply
Hanger
Media
Alignment
Spindle
Printhead
Open Lever
Take-up
Spindle
Rewind
Media
Guide
Thumbscrew
Printhead
Assembly
Transmissive
Sensor
Dancer
Value
Peel
Assembly
Rewind
Base
Assembly