ZyXEL Communications ES-3124 User Manual
Page 52
Chapter 4 The Web Configurator
ES-3124 Series User’s Guide
52
Spanning Tree
Protocol
This link takes you to screens where you can configure the RSTP/MRSTP/MSTP to
prevent network loops.
Bandwidth
Control
This link takes you to screens where you can cap the maximum bandwidth allowed
from specified source(s) to specified destination(s).
Broadcast Storm
Control
This link takes you to a screen to set up broadcast filters.
Mirroring
This link takes you to screens where you can copy traffic from one port or ports to
another port in order that you can examine the traffic from the first port without
interference
Link Aggregation This link takes you to a screen where you can logically aggregate physical links to
form one logical, higher-bandwidth link.
Port
Authentication
This link takes you to a screen where you can configure IEEE 802.1x port
authentication as well as MAC authentication for clients communicating via the
Switch.
Port Security
This link takes you to a screen where you can activate MAC address learning and
set the maximum number of MAC addresses to learn on a port.
Classifier
This link takes you to a screen where you can configure the Switch to group
packets based on the specified criteria.
Policy Rule
This link takes you to a screen where you can configure the Switch to perform
special treatment on the grouped packets.
Queuing Method This link takes you to a screen where you can configure queuing with associated
queue weights for each port.
VLAN Stacking
This link takes you to a screen where you can configure VLAN stacking.
Multicast
This link takes you to a screen where you can configure various multicast features
and create multicast VLANs.
Auth and Acct
This link takes you to a screen where you can configure authentication and
accounting services via external servers. The external servers can be either
RADIUS (Remote Authentication Dial-In User Service) or TACACS+ (Terminal
Access Controller Access-Control System Plus).
IP Source Guard This link takes you to a screen where you can configure filtering of unauthorized
DHCP and ARP packets in your network.
Loop Guard
This link takes you to a screen where you can configure protection against network
loops that occur on the edge of your network.
IP Application
Static Route
This link takes you to screens where you can configure static routes. A static route
defines how the Switch should forward traffic by configuring the TCP/IP parameters
manually.
DiffServ
This link takes you to screens where you can enable DiffServ, configure marking
rules and set DSCP-to-IEEE802.1p mappings.
DHCP
This link takes you to a screen where you can configure the DHCP settings.
Management
Maintenance
This link takes you to screens where you can perform firmware and configuration
file maintenance as well as reboot the system.
Access Control
This link takes you to screens where you can change the system login password
and configure SNMP and remote management.
Diagnostic
This link takes you to screens where you can view system logs and test port(s).
Table 6 Navigation Panel Links (continued)
LINK
DESCRIPTION