Xerox 470 - Manual (Page 302)

Page 15 - 10 Xerox Document Centre Reference Guide
Output
Quality
(cont’d)
There are streaks, lines,
spots, or black, solid, or
dotted lines l Clean the Document Glass, especially near
the black plastic ramp on the glass, if using
the Document Feeder.
l Run the job from the Document Glass.
l Check the quality of the original. Use
Border Erase or Edge Erase to remove
lines from the edges of the document.
l Turn on Background Suppression.
l Load fresh paper.
Image Loss l When copying a document from a larger
paper size to a smaller size, use Auto% to
reduce the image onto the smaller size.
l Use reduction i.e., copy at 90% instead of
100%.
l Select Auto Center and run the job again.
l If scanning from the Document Glass,
select Manual Platen Input and define the
document size. Register the document in
the left rear corner and copy with the cover
down.
l If using the Document Feeder, ensure the
document Size is correctly defined. Refer
to page 12 -19 for more information.
A message is displayed
that the machine cannot
sense the size of the
original on the glass l Select Original Size in the Image
Adjustment Tab and enter the size.
l Rescan the original, leaving the cover
raised.
Problem Symptom Recommendation