Remote node/dial-in user connection – ZyXEL Communications P-202 User Manual

Page 394

P-202H Plus v2 Support Notes

Lcp negotiation failed

- trace PPP packets

Ipcp negotiation failed

- check if IP address is correct
- check if IP is turned on in a remote node.
- check if SUA is needed

All others

- collect PPP traces

2. Remote Node/Dial-in User Connection

Related SMT screens and CI commands:

- SMT Menu 2
- SMT Menu 24.4.12
- SMT Menu 24.9

- isdn dial # (pre-ZyNOS) or dev dial # (ZyNOS)
- sys log disp

Cannot outcall to a Remote node

Use CI "isdn dial " to verify a outgoing call for a remote node. Use CI
'system event' an incoming call from a remote node.

The following are some possible failure reasons for a outgoing call:

- Dial failed ( please refer to previous chapter for more details. )
- ISDN protocol mismatched ( please refer to previous chapter for more
details. )
- Incoming only remote node, check Menu 11

•

Pre-ZyNOS:

P2864> isdn dial 1
* Dial not allowed, or No Channel ( Call to a incoming only remote node, or no
free B chan )
### Hit any key to continue.###

394

•

ZyNOS: