Xerox DocuColor 7000 EN - Manual (Page 66)

DocuColor 8000/7000 Operator Manual 2-10
2. Paper and paper trays
Drilled paper
Three-hole drilled paper can be run from all the trays either LEF or
SEF with the holes facing any direction.
NOTE: If you are stapling 3-hole drilled paper with the optional
High Capacity Stacker Stapler 80 (HCSS80), refer to the
Accessories chapter for paper loading instructions, based on the
position of the staple.
Drilled paper should be run in the Simplex (1-sided) and Duplex
(2-sided) orientations shown below to avoid paper jams caused by
the holes not aligning correctly with the paper sensor in the press.
Simplex Print Jobs
Load the drilled paper into any tray in the Long Edge Feed (LEF)
direction. Refer to the following illustration:
Duplex Print Jobs
Load drilled paper into any tray in either the Long Edge Feed
(LEF) or Short Edge Feed (SEF) direction. Refer to the following
illustration:
NOTE: If you are stapling 3-hole drilled paper with the optional
High Capacity Stacker Stapler 80 (HCSS80), refer to the
Accessories chapter (see page 3-27 and page 3-43) for paper
loading instructions, based on the position of the staple.
Rear of paper tray
Front of paper tray
guides
tray
Paper Right
side
Rear of paper tray
Front of paper tray
SEF direction
Paper
tray
guides
Rear of paper tray
Front of paper tray
LEF direction
guides
tray
Paper Right
side