Xerox DocuColor 7000 EN - Manual (Page 111)

DocuColor 8000/7000 Operator Manual 3-37
3. Accessories
HCSS80 Maintenance
Cleaning the HCSS80
Do not clean any area inside of the HCSS80. If the HCSS80
covers require cleaning, dampen a paper towel or soft, clean cloth
with a liquid, nonabrasive glass cleaner or water.
To avoid damage to the HCSS80, do not pour or spray the cleaner
or water directly onto the HCSS80. Always apply the liquid to the
cloth first.
Do not use any other cleaners or solvents on the HCSS80 or they
may interact with the paint on the covers, eventually causing the
paint to peel.
Problem Solving
If after reviewing the Problems and following the recommended
solutions the problem persists, call for assistance.
Problem Cause Solution
Fault Code 112-100
Jam indicated in
HCSS80, but actually
is in the Exit Module.
Jammed Paper not
visible in HCSS80, and
fault code does not clear
after opening and
closing HCSS80 door.
• Open the HCSS80 door.
• Jammed paper is not visible in the area indicated.
Close the HCSS80 door.
• The Touch Screen indicates a jam in the Exit
Module. Open the Exit Module and clear any
visible sheets.
• Open and close the HCSS80 door.
• Clear any other areas indicated on the Touch
Screen.
Fault Code 112-100
Jam indicated in
HCSS80.
No visible jams in
HCSS80 because
sheet is located over
the Exit Module
sensor.
Paper jammed between
Exit Module and
HCSS80 sensors
• Open the HCSS80 door.
• Jammed paper is not visible in the area indicated.
Close the HCSS80 door.
• If the fault code remains, open the Exit Module. No
jammed sheets are visible.
• Undock the HCSS80. Find the jammed sheet
between the Exit Module and the HCSS80. Refer
to the Note below this table for information on how
to undock the HCSS80.
• Clear any other areas indicated on the Touch
Screen.