Xerox DocuColor 7000 EN - Manual (Page 112)

DocuColor 8000/7000 Operator Manual 3-38
3. Accessories
Fault Code 112-130
Jam indicated in
HCSS80, but is also
in Exit Module.
Paper is jammed over
both the Exit Module and
HCSS80 sensors.
• Open the HCSS80 door.
• Clear any visible jams.
• If no jammed paper is visible in the HCSS80 area
indicated, open the Exit Module door and clear
any jammed paper. Close the Exit Module door.
• Open and close the HCSS80 door.
Fault Code 112-130
Jam indicated in
HCSS80.
Paper is jammed
between the
Exit Module and the
HCSS80 sensors.
• Open the HCSS80 door.
• If no jammed paper is visible in the area indicated,
open the Exit Module door and clear any jammed
paper. Close the Exit Module door.
• Open and close the HCSS80 door.
• If the fault persists, undock the HCSS80 and clear
the jammed paper between the Exit Module and
the HCSS80. Refer to the Note below this table for
information on how to undock the HCSS80.
Fault Code 112-110 Paper jammed in the
HCSS80 and the Exit
Module during a purge of
sheets to the Top Tray.
• Clear the jammed paper from the HCSS80.
• Clear the jammed paper from the Exit Module.
• Open and close the HCSS80 door.
• Resume job.
Fault Code 052-310 Communication problem • Cancel or save the job.
• Power off the digital press. Wait 15 seconds and
power on.
Fault Code 052-321 Connection problem • Cancel or save the job.
• Power off the digital press. Wait 15 seconds and
power on.
Fault Code 052-320 Unexpected connection • Cancel or save the job.
• Power off the digital press. Wait 15 seconds and
power on.
Fault Code 052-312 Communication problem • Cancel or save the job.
• Power off the digital press. Wait 15 seconds and
power on.
Ready Indicator does
not illuminate
No power • Check the power cord connected to the power
source.
• Check that the main switch is on.
Problem Cause Solution